Metal Elements Brass Hollow Rivet for Metal Stamping, 1/16dia 1/16 length, 100 pcs

shipping

Free Delivery (UK Only)

Free for orders over £25.00

Order by 3pm for same day postage

  • £7.03
  • £4.22

  • Ex Tax: £3.51

  • 1 or more £4.22
Add to Favourites

To rivet:

  1. Simply punch or drill a 1.6mm hole into your pieces, slide the rivet through both pieces.
  2. Cut excess length off the rivet end to about 1/16'.
  3. Lay your pieces on a hard surface, preferably a rubber block and a steel bench block (available in our tools section), with the nail head facing down and the rivet end slightly protruding.
  4. Lightly tap, using a ball peen or chasing hammer, the rivet end so it spreads out slightly over the hole opening. Gradually increase the intensity of the hammer taps until both pieces are secure.

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha